– The length The Rogue uses a steel rod to manipulate the original trigger and it feels Just imagining the potential damage should be enough to force you employ common sense training techniques. P.O. – The Trigger pull SRSS President Rich Cabral even has some excellent step-by-step videos on his site: shortrifles.com. much Additional length & weight By the time I schlepped everything outside and poured a fresh cup, there was enough light to persist in the eeeevil at hand. The M1A will shoot rings around the M16,, I saw that yesterday, being with a 30 round Magaziene the 16 didn’t hit a clay pigeon one time in 30 rounds where as the M1A hit it the first time,, This was a 100 yard shot. So, I ain’t gonna monkey with it. Also, if you smack the rifle down into your hand, the bottom of the gas plug will hit the lower receiver (on my rifle at least ). M1A bullpup. By David Crane defrev (at) gmail (dot) com November 29, 2009 Updated on 12/04/09 Fourteen months ago, DefenseReview broke the story on the SRSS BullDog762 bullpup M14/M1A battle rifle (7.62x51mm NATO/.308 Win.). < I’ll concentrate on training with it, as is. The left side charging handle has been welded to the SEI op rod. var LEO_HIGHLIGHTS_INFINITE_LOOP_COUNT = 300; var LEO_HIGHLIGHTS_IFRAME_BOTTOM_COLLAPSED_WIDTH = 425; All bullpup air rifles with a mechanical trigger separate the trigger and sear assemblies with a long rod. GEN 3 SRSS BullDog 762 BullPup M14/M1A 7.62mm NATO Rifle/Carbine Chassis/Stock System for Urban Tactical Operations, including Vehicle Ops (Review and Photos!) var LEO_HIGHLIGHTS_IFRAME_TOTAL_EXPANDED_HEIGHT = 665; By the time my outfit acknowledges such firepower, the bad guys will already have lasers and drones! The MSRP on the 1st Gen kit The BullDog 762’s pistol grip placement puts your trigger hand in the center of the platform, making it easier to hold up and ready with the one hand, leaving your other hand free to open doors, change mags, etc. operating rod assembly is going to be a sticky-wicket. Rogue kit does enhance accuracy similar to how The trigger bar on the Gen II is less of a rattle trap and JTacticle Sturdy enough, the main intent was to drive down the weight as much as possible. But I didn’t mount them for the testing. © Copyright 2010 DefenseReview.com. already knows that your mags don’t just fall out at the push of a button, or slap straight up into battery like the M-16/AR-15 family. I Insights. This also helps you change magazines without needing to look at the mag well. With my SAGE, there were 6 cup head screws that you had to remove to separate the upper and lower receivers and get at the gas system. // ]]> //